Linux ARM9 System On Module

M-502

ATMEL 9G20, Linux-ready 128-pin System On Module

  • Linux kernel 2.6.29 with file system
  • CPU: ATMEL AT91SAM9G20 w/MMU, 400MHz
  • Flash: 256MB, NAND type
  • SDRAM: 64MB
  • Ethernet interface: 1 x 10/100Mbps
  • USB Host interface: 2 x USB 2.0 compliant
  • SD card interface: 1 x 32GB max.
  • UART: 4 x 921.6kbps w/ hardware flow control
  • I2C interface: yes
  • I2S interface: yes, including 1 x transmitter and 1 x receiver
  • SPI interface: yes, w/ 2 x chip select signals
  • GPIO interface: 32 pins, CMOS / 3.3V compatible
  • Local bus: 8 bits, including A0-A7, D0-D7 and 3 x chip selects
  • Dimension: 80mm x 50mm
  • Power input: 80mA@3.3V
  • GNU C/C++ toolchain for Linux and Windows

M-9G45A

ATMEL 9G45, Linux-ready 128-pin System on Module
with TTL LCD interface, 1 x LAN, 4 x UART ports
and 1 x 480Mbps USB2.0 compliant Host port

  • Linux kernel 2.6.38 with file system
  • CPU: ATMEL AT91SAM9G45, 400MHz
  • Flash: 256MB, NAND type
  • SDRAM: 128MB DDR2
  • LCD interface: TTL (24-bit), up to 1280 x 860 pixels
  • Ethernet interface: 1 x 10/100Mbps
  • USB Host interface: 1 x USB 2.0 compliant supports high speed mode (480Mbps)
  • SD card interface: 1 x 32GB max.
  • UART: 4 x 921.6Kbps w/ hardware flow control
  • I2C interface: yes
  • I2S interface: yes, including 1 x transmitter and 1 x receiver
  • SPI interface: yes, w/ 2 x chip select signals
  • GPIO interface: 15 pins, CMOS / 3.3V compatible
  • Dimensions: 80mm x 50mm
  • Power input: 80mA@3.3V
  • GNU C/C++ toolchain for Linux and Windows

M-9G45A Starter Kit

Starter Kit for M-9G45A System On Module

  • One M-9G45A system on module
  • One carrier board with the following interface:
    • LCD interface (TTL): 2
    • LCD interface (LVDS): 1
    • Backlight Controls: 2, for 5V or 12V LCDs
    • Touchscreen interface: 4-wire, resistive type
    • Ethernet: 1 x 10/100Mbps
    • TTY: 1 x RS-485 and 3 x RS-232
    • USB Host: 4 x USB 2.0 compliant
    • USB Client: 1 x USB 2.0 compliant
    • GPIO: 15 pins, CMOS / TTL-level
    • micro-SD socket: 1
    • Audio: 1 x input and 1 x output
    • Status LEDs: for power, Etherent and TTY ports
    • Power input circuitry (9~30VDC)
    • Carrier board circuitry schematics (pdf)
    • GNU C/C++ toolchain for Linux and Windows